Grass Valley Kameleon HD Multi-Function Modules v.2.5.0 - Manual (Page 22)

22 Kameleon HD—Instruction Manual
Configuration and Adjustments
Enable minimum delay
mode
Disabled Enabled or Disabled
Frame Sync/
Minimum Delay Mode
Enable checkbox
N/A
Frame Sync
controls appear only
on the KAM-HDD-FS
or KAM-HD-FS
modules. T
Timing reference is
set on System
Config web page.
For KAM-HDD and
KAM-HDD-PA tim-
ing, see
Kameleon
HD Timing Consid-
erations on page 20
.
Adjust horizontal timing
in pixels
0 pixels
HD 59.94:
1080i/59.94 = 0 to 2199
720p/59.94 = 0 to 1649
SD:
480i/59.94 = 0 to 857
576i/50 = 0 to 863
HD 50:
1080i/50 = 0 to 2639
720p/50 = 0 to 1979
HD 24:
1080sf/24 = 0 to 2749
1080p/24 = 0 to 2749
(1 pixel steps)
Frame Sync/
Timing Adjustments
H Timing control
HTiming
Adjust vertical timing
in lines
0 lines
HD 59.94:
1080i/59.94 = 0 to 1124
720p/59.94 = 0 to 749
SD:
480i/59.94 = 0 to 524
576i/50 = 0 to 624
HD 50:
1080i/50 = 0 to 1124
720p/50 = 0 to 749
HD 24:
1080sf/24 = 0 to 1124
1080p/24 = 0 to 1124
(1 line steps)
Frame Sync/
Timing Adjustments
V Timing control
VTiming
Loss of signal operation
(Frame Sync reference
timing source selected)
Auto Freeze
Pass,
Auto Freeze,
or Auto Blue
Frame Sync/
Loss of Signal Operation
Pass, Auto Freeze, or Auto Blue
radio button
LOS Oper
Manual Freeze mode None
None, Frame, or Field
(SD input only)
Frame Sync/
Manual Freeze Mode Selection
None, Frame or Field radio button
ManFrzMode
Table 3. Summary of Kameleon HD Configuration Controls
Function Default
Range/Choices
Resolution
Web Page/
Function Name
Newton
Panel
Notes/
Conditions