Grass Valley K2 Level 2 RAID Oct.10 2006 - Manual (Page 45)

September 8, 2006 Level 2 RAID Instruction Manual 45
Interpreting expansion adapter status LEDs
Interpreting expansion adapter status LEDs
Use the following illustration and table to identify and interpret expansion adapter
LEDs
.
LED Action Meaning
Ready
(Green) On Module is powered on and initial diagnostics completed normally
Fault
(Orange) On Fault in the module.
Also on at power-on and then off at the completion of the self-test.
Fibre
Channel In
Linkup On Fibre Channel In port (from primary RAID chassis) is operable and linked up.
Off or
flashing Self-test or initialization just after power-on.
Fibre
Channel
Out
Linkup On Fibre Channel Out port is operable and linked up. This port is not used.
Off or
flashing Self-test or initialization just after power-on.
Expansion
Chasssis
Diag On The expansion chassis is connected with the primary RAID chassis through
the diagnostic cable and ready for diagnosis.
Flashing The LED blinks just after power-on or when no expansion chassis diagnosis
cable is connected.
FC –OUT FC –IN
ENC ID
PORT1 PORT0
FLT RDY
DIAG ID
DIAG RDY
DE—DIAG
Ready Fibre Channel
Out Linkup
Fault
Fibre Channel
In Linkup Expansion
Chassis Diag