Grass Valley K2 Level 2 RAID Oct.10 2006 - Manual (Page 40)

40 Level 2 RAID Instruction Manual September 8, 2006
Chapter 3 Servicing the K2 Level 2 RAID
required for NetCentral monitoring resides on the RAID storage device itself. As a
result, the K2 Level 2 RAID appears in NetCentral as a standalone device rather than
as a subsystem of the K2 Media Client.
Communication with NetCentral takes place over the LAN card Ethernet port. To
monitor the K2 Level 2 RAID, you must connect network cabling, power on the
system, then configure network and SNMP settings as described in the K2 Storage
System Instruction Manual.
If you have the K2 Level 2 expansion chassis, you must connect the diagnostic
cabling, as it is required for NetCentral monitoring.
Refer to the NetCentral On-line Help for information on monitoring the K2 Level 2
RAID with NetCentral.