Grass Valley K2 Level 2 RAID Oct.10 2006 - Manual (Page 25)

September 8, 2006 Level 2 RAID Instruction Manual 25
Chapter
2
K2 Level 2 RAID Installation Information
This chapter describes information you’ll need to install the K2 RAID Storage (K2
Level 2 Expansion Chassis). Major topics are:
• “Installation requirements”
• “Installing a K2 Level 2 RAID Storage in an equipment rack”
• “K2 Level 2 RAID Storage power-up and initialization”
• “K2 Level 2 RAID Storage power-down”
Installation requirements
This section describes the following requirements:
• “Site requirements” on page 25
• “Controller configuration requirements” on page 26
• “Addressing requirements” on page 27
• “Cabling requirements” on page 30
• “Binding disk modules into groups” on page 30
Site requirements
For proper K2 Level 2 Expansion Chassis operation, the installation site must
conform to certain environmental specifications. These are detailed below and in
Chapter 4, K2 Level 2 RAID Technical Specifications and Operating Limits .
Power
Refer to “AC power requirements” on page 61 for AC power requirements. The
values indicate either the values for the power cord of a K2 Level 2 Expansion Chassis
with a single power supply, or the total values shared by the line cords of two power
supplies in the same K2 Level 2 Expansion Chassis, with the division between the
power cords and supplies at the current sharing ratio. If one of the two power supplies
fails, the remaining supply and cord must support the full load. You must use a rack
mount cabinet with ac power distribution, and have main branch ac distribution that
can handle these values for the number of K2 Level 2s and K2 Level 2 Expansion
Chassis units that you will interconnect.
Cooling
Make sure your site has air conditioning of the correct size and placement to maintain
the specified ambient temperature range. The air conditioning must be able to handle
the requirements of the K2 Level 2s and any connected K2 Level 2s as indicated under
“Environmental limits” on page 62 .