Addressing requirements, Set the switch to – Grass Valley K2 Level 2 RAID Oct.10 2006 User Manual

Page 29

September 8, 2006

Level 2 RAID Instruction Manual

Addressing requirements

Set the switch to

for both the left and right expansion adapters installed in the

Expansion chassis.

NOTE: When the switches of the left and right adapters are set differently, the
FAULT LEDs blink and the Expansion chassis is not started. If different values are
set, turn off the power of the system including the Expansion chassis, re-set the
values to

, and turn on the power again.

Expansion chassis diagnostic switch setting requirement

A K2 Level 2 primary RAID chassis has no expansion chassis diagnostic switch, so
no configuration is necessary.

The expansion chassis diagnostic ID switch sets the diagnosis path address of the
Expansion chassis. This is required for NetCentral monitoring. Each K2 Level 2
expansion chassis has the switch that must be set to 0, which is the factory-set value.
The expansion chassis diagnostic switch is located on the expansion adapter. The
following figures show how to use the switch.

Set the switch to

for both the left and right expansion adapters installed in the

Expansion chassis.

FC –OUT

FC –IN

ENC ID

PORT1

PORT0

FLT

RDY

DIAG ID

DIAG RDY

DE—DIAG

Chassis address switch