Grass Valley K2 Level 2 RAID Oct.10 2006 - Manual (Page 26)

26 Level 2 RAID Instruction Manual September 8, 2006
Chapter 2 K2 Level 2 RAID Installation Information
Controller configuration requirements
The default settings for the controller DIP switches are shown in the following
illustrations and table. Remove the controller, as explained in
“Removing a RAID
controller or expansion adapter” on page 50 , and verify that the default settings are
intact.
Switch position Bit position Setting position and function
A9E2 1 Fixed to OFF (HDD Spin-up Mode, OFF: Command, ON: Auto)
2 Fixed to ON (Operation Mode, OFF: NF1200, ON: NF1300)
3 OFF by default (Topology, OFF: FC_AL, ON: Fabric)
4 Fixed to OFF (MD Mode, OFF: Normal, ON: Long MD)
A9E1 5 Fixed to ON
6 Fixed to OFF
7 Fixed to OFF
8 Fixed to OFF
Access DIP switches
from the bottom of the
controller module
4 3 2 1 4 3 2 1 4 3 2 1
1 2 3 4 5 6 7 8 9 A B C
OFF
A9D A9E1 A9E2
Connector on
backboard side
of controller
Verify these settings