Grass Valley K2 10G RAID - Manual (Page 63)

63
K2 10G RAID Storage Instruction Manual 18 November 2010
Chapter 3 Servicing the K2 10G RAID
• Wait at least three minutes after removing the previous disk module.
• Put a location label on the replacement disk drive, as appropriate for the slot into
which it is installed.
To install a disk module:
1. Open the lever of the disk module, as demonstrated in “Removing a disk module”
on page 61 .
2. Insert the drive in the unit.
3. Insert the drive as shown in the following diagram.
4. Close the lever all the way.
The disk spins up automatically upon installation and, if the inserted disk is a
0
2
1
3
3
Guide
Insert until the end of
the lever touches the
guide