Grass Valley K2 10G RAID - Manual (Page 49)

49
K2 10G RAID Storage Instruction Manual 18 November 2010
Chapter 2 K2 10G RAID Installation Information
K2 10G RAID power-up and initialization
This section gives information about connecting power and powering-on the
K2 10G RAID system.
Connecting electrical cables
For each chassis, there are two electrical cables (one for each power supply) that
should be connected to separate outside power sources.
WARNING: Make sure the power cords meet local safety and electrical
standards.
CAUTION: The K2 10G RAID system must be electrically grounded.
Operating the system without proper grounding can damage disk
drives. If the outlet you use is not grounded, make sure that a licensed
electrician replaces it and installs a grounding conductor.
To prevent the plug from being inadvertently disconnected, secure the electrical cable
into the outlet by doing the following:
1. Check that the power switch on the RAID chassis and those on the host system are
all set to OFF.
2. Insert the power cord into the power supply.
3. Secure the power cord with the power cable clamp.
4. Insert the plug of the power cord into an AC outlet. Use a grounded AC outlet.
Powering-up the K2 10G RAID system
1. Verify power and cabling.
2. Press and hold down the power button on the controller, as shown.
!
!