Grass Valley iTX Delivery Manager v.2.6 - Manual (Page 82)

76
User Operations
Viewing a partially restored media file
2 Search for an asset that has been partially stored and select it.
When the media viewer in the iTX Desktop is set to Auto Load it will, by default, load
the largest file available for the clip. However, if set to Manual , it will list the locations of
available media files that contain the complete media for that particular asset.
For each asset the following information is shown:
• The location type (e.g. proxy or iTX)
• The storage format or media container (e.g. MPEG-4)
• The location (e.g. SVR2561)
• A time line graphic that represents the length and position of the clip in relation to
the parent media.
The gray section of the time line represents the length of the media containing that
clip. The yellow section represents the length of media in the specific location. The
triangular markers show the in and out points of the clip.
3 Hover the mouse pointer over an entry to view more details, as pictured below:
4 Click on an entry in the list. The corresponding clip loads in the viewer.
Note: Timelines only show for clips that have locations for partially restored
media.
5 Click the All Media tab to view full details of all media files that co-reference the same
parent media: