Grass Valley iTX Delivery Manager v.2.6 - Manual (Page 67)

61
Delivery Manager
Configuration and Setup Guide
Additional Setup for Manual/Export Mode
If you have configured Delivery Manager with an endpoint in manual or Export mode, the
following services and configurations are required.
• Install the iTX Workflow service
• Configure Delivery Manager Workflows , including:
• Configuring the Manual Archive workflow
• Configuring a Manual Restore workflow
• Configuring the ShotList Export workflow
Note: If you are using a DIVArchive, additional steps are required in order to
operate in Manual Mode. See Prerequisites for DIVA Endpoints in Manual
Mode , on page 27 for more information.
Install the iTX Workflow service
All manual operations use Workflows that are external to Delivery Manager, therefore iTX
Workflow must be installed on your iTX System.
For full details on installing and configuring iTX Workflow, please see the section entitled
“Using iTX Workflow” in the iTX System Administrator Guide.
Configure Delivery Manager Workflows
Once Workflow has been installed you need to configure the default Delivery Manager
workflows (from those added by MediaFlow Delivery Manager Processes). This is performed
using the Workflow Configuration tool.
To access the Delivery Manager workflow configuration:
1 On the computer that has the Workflow Service is installed go to Start > All
Programs > iTX 2.0 > Workflow Service Config. The Workflow Configuration
window appears.
2 Select the Simple tab.