beautypg.com

Adding a pathfire endpoint, Prerequisites for pathfire endpoints – Grass Valley iTX Delivery Manager v.2.6 User Manual

Page 40

background image

34

Adding 3rd Party Endpoints

Adding a PathFire Endpoint

14 In the MassTech Archive Configuration section, complete the following fields:

Setting

Description

Manager IP address

The IP address of MassTech.

Username/Password

This information is usually supplied by MassTech.

Note: Only one connection at a time can be made using a

single account, so the endpoint may not be able to connect if

something else is already using it.

MassTech ID of Store

for iTX Media

This is the Server ID configured in the MassTech for the iTX

media server from which media is archived and to which media

is restored. This has to be configured by MassTech.

Allow Media Deletes

This option should be enabled if you wish to be able to delete

any media assets from MassTech.

Timeout (minutes)

This defaults to 60. If a job has not progressed at all in this time

frame it will be cancelled.

Allow Overwriting

Archive

Leave this option disabled for normal operations.

Monitor MassTech

for Changes

Leave this option disabled for normal operations.

15 Click Save then Close.

16 Restart the Delivery Manager service. See

Restarting an iTX Service

on page 53 for

more information.

17 Finalize the Delivery Manager setup:

• To use a MassTech endpoint in Search Media mode, you must also complete the

steps described in

Additional Setup for Search Media mode

, on page 59.

• To use a MassTech endpoint in manual mode, you must also complete the steps

described in

Additional Setup for Manual/Export Mode

, on page 61.

Adding a PathFire Endpoint

PathFire endpoints only operate in Search Media Mode.

Prerequisites for PathFire Endpoints

If you are running Windows Server 2008 R2 or Windows Server 2012 you will also need to
install Windows Message Queuing in order for the PathFire Service to run correctly.

To install Message Queuing on Windows Server 2008 R2 and Windows Server 2012:

1 From Windows, click Start > Programs > Administrative Tools > Server Manager. The

Server Manager application opens.

2 Click Add Features.

This manual is related to the following products: