Grass Valley iTX Delivery Manager v.2.6 - Manual (Page 38)

32
Adding 3rd Party Endpoints
Adding MassTech Endpoints
15 In the Diva Archive Configuration section, complete the following as required:
Setting Description
Allow Overwriting
Archive When moving an asset to the archive, this checkbox allows
overwriting of an asset if it already exists on the DIVA.
If not enabled then archive jobs will fail if the object already exists
on the DIVA in the category of the endpoint.
Monitor DIVA for
Changes If this checkbox is enabled, the endpoint regularly checks the DIVA
for objects in the category of that endpoint that have been
created, modified, or deleted and update iTX accordingly.
The status of the connection to the DIVA of each endpoint is
checked every 30 seconds. If the connection is lost, the health
indicator turns red for the endpoint on the Delivery Manager
Service.
It automatically tries to reconnect to the DIVA. If the
connection is re-established, the status light returns to green.
Max Concurrent
Jobs
The highest number of jobs that are allowed to run
simultaneously from that endpoint.
Manager IP
Address
The IP address of the DIVArchive Manager Server.
Port The TCP/IP Port that the endpoint communicates with the
archive on.
16 Click Save then Close.
17 Restart the Delivery Manager service. See Restarting an iTX Service on page 53 for
more information.
18 Finalize the Delivery Manager setup:
• To use a DIVA endpoint in Search Media mode, you must also complete the steps
described in Additional Setup for Search Media mode , on page 59.
• To use a DIVA endpoint in manual mode, you must also complete the steps
described in Additional Setup for Manual/Export Mode , on page 61.
Adding MassTech Endpoints
MassTech endpoints are able to operate in Content Change and Search Media, depending
on whether or not certain workflows are selected during the configuration.
IMPORTANT
You should not attempt to operate a single endpoint configuration in more
than one mode. For example, if you are using the MassTech archive in
Content Change mode you should select a
Content Changed Workflow
and not select a Cache Content Workflow within the same configuration
profile.