Grass Valley 8985FS v.1.2.0 - Manual (Page 65)

8985FSP/FS/PRC — Instruction Manual 65
Specifications
Specifications
Table 4. 8985FSP Specifications
Parameter Value
Serial Digital Input
Number and type of input 1 non-isolated terminating BNC
Input impedance 75 ohm
Input return loss > 15 dB from 5 MHz to 1.5 GHz
Input signal level 800 mV +/- 10%
Input DC tolerance +/- 0.25 mV maximum
Serial mode hum voltage 1 V p-p to 60 Hz maximum
Common mode rejection ratio (CMMR) N/A
Auto equalization 325 meters of Belden 1694A or 270 Mb/s
125 meters of Belden 1694A for 1.5 Gb/s
Reclocking Yes
Input lock range +/- 100 PPM
Input signal type HD-SDI:
1080i 59.9 / 50
1080p24/sF24
720p 59.9 /50
SD-SDI:
480i59.9
576i50
Reference Signal Input (8900GEN-SM Genlock Submodule Installed)
Signal Type:
Analog color black 525i/59.9(NTSC); 625i/50(PAL-B); SMPTE318M
(NTSC with 10 field AES ID)
Tri-level sync 720p59.94; 1080i59.94, 720p50, 1080i50, 1080p24, 1080sF/24
4 V composite sync Not supported
Active video Not supported due to effects on timing
Reference signal level 300 mV p-p +/- 6 dB
Reference signal to noise ration (S/N) > 46 dB S/N
Serial Digital Outputs
Connector type Coax BNC, optional fiber optic SFP
Number of outputs 4
Output impedance 75 ohm
Return loss > 15 dB 5 MHz-270 MHz
> 15 dB typical 270 MHz - 1.5 GHz
Output signal level SDI 800 mV p-p, +/- 10%
Rise/fall time (20-80%) 140 ps for HD
500 ps for SD
Output jitter
(FS mode, in low jitter mode) < 0.2 UI > 100KHz for HD
< 1.0 UI 10 Hz-100KHz for HD
< 0.2 UI 10 Hz and up for SD