Grass Valley 8985FS v.1.2.0 - Manual (Page 41)

8985FSP/FS/PRC — Instruction Manual 41
Configuration
System Config Web Page
Use the System Config web page ( Figure 23 on page 44 ) to set the following
system configuration parameters for the module:
Input Video
Use the following controls to set the video input type and rate. Refer to
Table 6 on page 75 for a complete list of available input types and rates.
• Input Type – select the radio button corresponding to the desired input
type.
• Input Rate – select the desired input rate from the pulldown.
Note The input video must be set to the same frame rate (or compatible frame rate
as listed in
Table 2 on page 45 ) as the reference input when the input video
is associated with the reference input in the Output Timing controls for proper
genlocking.
Pressing the Defaults button or changing the Input Type from HD to SD on
the System Config web page or with an E-MEM recall will cause the
module to reboot. It will take approximately 30 seconds to re-initialize.
During this time a Wait Page (
Figure 22 ) will appear. Wait for the operation
to complete then select the Refresh button to update the web page.
Figure 22. Wait Page
Test Output
An internally generated colorbars test signal may be enabled on the output
of the module by checking the
Enabled checkbox. Be sure to disable this
output before going on-air.
Output Timing
Select the Primary and Secondary output timing source for the module as
either
Local (external reference from the 8900GEN-SM submodule mounted
on this module), Ref Bus 1 (8900GEN-SM submodule is mounted on module
in slot 1 and jumpered for outputting a Ref 1 frame bus), Ref Bus 2
(8900GEN-SM submodule is mounted on module in slot 3 and jumpered
Use
this
link
Refresh button