Grass Valley 8985FS v.1.2.0 - Manual (Page 14)

14 8985FSP/FS/PRC — Instruction Manual
Installation
Rear Module Installation
Each 8900GFR-R rear module or blank rear adapter cover is held in place
by two retainer strips as shown in
Figure 2 . To install a rear module into the
frame, follow these steps:
1. Loosen (but do not remove completely) the two screws holding each
retainer strip to the frame with a 2 mm (5/64”) hex screwdriver. Pull up
on the retainer to remove it, leaving the screws in place.
CAUTION Be careful to leave the screws in place as they can be easily lost or fall into
equipment below the frame creating a shorting hazard.
2. Remove the blank rear adapter cover by inserting needlenose pliers
into the slots in the top and bottom of the blank and pulling it off.
Note To remove a rear module already installed, follow the same steps. It is helpful
to first remove the front module so the rear can be pulled out more easily.
3. Insert the rear module into the empty slot.
4. Replace each retainer strip over the two screws on both sides of the
module and push down to seat the retainer.
5. Tighten the screws for each retainer just until they are snug. Do not
force or torque the screws too tightly.
Figure 2. Installing Rear Module
Use needlenose pliers
to pull out blank after
removing retainers.