Grass Valley 8985FS v.1.2.0 - Manual (Page 19)

8985FSP/FS/PRC — Instruction Manual 19
Installation
Cabling
Cabling is done on the rear BNCs of the 8900GFR-R module illustrated in
Figure 7 . Inputs and outputs are also illustrated on the I/0 Config web page
( I/O Config Web Page on page 38 ).
Note It is recommended to clean the fiber optic cable connectors with a lint-free,
anti-static cloth before making a connection to the fiber optic submodule.
Figure 7. 8900GFR-R Rear Module
Video Inputs
Connect an HD or SD digital video signal to the Coax input at BNC J9,
and/or to one or both of the fiber inputs at fiber connector J10 (depending
on the type of fiber submodule installed).
Note Refer to Table 2 on page 45 for important video input and external genlock
reference input video frame rate compatibility information.
For fiber optic inputs, the 1310-DRL or 1310-TRL SFP optical submodule
must be installed. Fiber inputs must be enabled with remote controls. Only
one video input can be used at a time and must also be selected with remote
controls.
8431_02r1
8900GFR-R
Fiber Optic Cabling
FIBER
J1 J2
J3 J4
J5 J6
J7
J9
J8
J1 and J3:
Genlock Loop
J9: Coax In
J5: SDI Out
Fiber Rx 1
Fiber Tx 2
Fiber Rx 2
J7: SDI Out J8: SDI Out
Fiber Inputs/Outputs
(See Fiber Optic Cabling
at right.)
J6: SDI Out
J2: Auto Tracking
Delay Output
J4: Auto Tracking
Delay Output
1310NM-DRL
Fiber Tx 1
Fiber Rx 1
Fiber Tx 2
1310NM-DTL
1310NM-TRL