Grass Valley 8985FS v.1.2.0 - Manual (Page 40)

40 8985FSP/FS/PRC — Instruction Manual
Configuration
Video Input Web Page
Use the Video Input web page ( Figure 21 ) to select and monitor the video
input source to the module with the following:
Video Input Selection
This section provides the following for the video input signal:
• Select Input Video – select the input source from the rear module from one
of the following:
• Coax – corresponds to BNC input J9.
• Fiber RX 1 – will be present when either the 1310NM-DRL or
1310NM-TRL submodule is installed, or
• Fiber RX 2 – will be present when the 1310NM-DRL submodule is
installed.
• Signal Name – the signal name defined on the I/O Config web page will
appear in each field.
• Signal State – this field reports the status of the input video signal as
Present , Not Present , or Not Supported (no fiber submodule installed).
Figure 21. Video In Web Page
Use
this
link