Grass Valley 8977AP-4B - Manual (Page 48)

48 8977AP-4B/4U — Instruction Manual
Remote Configuration
3. This will bring up the Choose File screen shown in Figure 31 .
Figure 31. Choose File Screen
4. Select a file to load and then press Open to bring the file into the filename
field.
5. Press the Load button in the Load From... web page ( Figure 30 on
page 47 ) to load the file to the module.
Recall Factory Defaults and Names
Use the two buttons at the bottom of the web page to do the following:
• Set Factory Defaults – select the Set Factory Defaults button to recall factory
settings to the module. Defaults for all module parameters are listed in
Table 5 on page 61 .
• Set Factory Names – select the Set Factory Names button to recall factory
signal names to the module. Defaults for all signal names are displayed
on the I/O Config web page shown in
Figure 18 on page 31 and
Figure 19 on page 32 .