Grass Valley 8977AP-4B - Manual (Page 36)

36 8977AP-4B/4U — Instruction Manual
Remote Configuration
Delay Web Page
Use the Delay web page ( Figure 23 on page 37 ) for the following:
• Input Stream – name of the input.
• Input Name – name given in the I/O Config web page.
• Delay Adjust – setting delay adjustments for each channel of the four
streams.
• Delay both ch1&ch2 – setting delay adjustments for both channels together
of the four streams.
• Tracking Delay – enable or disable the delay tracking. The amount of delay
tracking input status will be reported for each audio stream.
• Total Delay – the total amount of delay (Delay Adjust + Tracking Delay)
will be reported in the Total Delay field for each audio stream.
Note When a delay has been applied to a channel on a stream, removing and rein-
serting the module or disconnecting and reconnecting the audio input may
cause a disturbance on the undelayed channel or stream for a period equal to
the delay.
In the case of a Non-PCM audio (input stream 2 as shown in Figure 23 on
page 37 ), a delay may only be applied on the stream. Channel delay shift is
not available. The input name is reported in pink.
In the case of Sync PCM audio (input streams 3 and 4 in Figure 23 on
page 37 ), no tracking delay is applied and the function is grayed out.
Note If a Non-PCM audio signal is detected and another audio mode is forced, a
warning “Input Stream is detected as Non-PCM” appears between the input
streams (not shown).
Use
this
link