Grass Valley 8977AP-4B - Manual (Page 13)

8977AP-4B/4U — Instruction Manual 13
Installation
Installation
The 8900GEN-SM Genlock submodule will ship in a separate package, not
installed on the front module.
To install a Genlock submodule, follow these steps:
1. Locate the Genlock connector J7, on the back side of the 8977AP circuit
board (
Figure 3 ).
2. Line up the connector on the submodule, J1, with J7 on the front
module and snap the submodule into place making sure the holes in
each circuit board line up.
3. To hold the submodule in place, attach the captive screw provided from
the top of the front module to the standoff on the submodule circuit
board.
Figure 3. Installing 8900GEN-SM Genlock Submodule
Install Genlock submodule
on back of circuit board.
Center submodule connector J1
over front module connector J7
and snap in place. From top side
of module, tighten the screw
provided to the standoff on the
circuit board.
8521_08