Input status and settings web page – Grass Valley 8977AP-4B User Manual
Page 34
34
8977AP-4B/4U — Instruction Manual
Remote Configuration
Input Status and Settings Web Page
Use the Input Status and Settings web page (
) for the
following:
Audio Inputs
•
Input Stream Name
– the signal name defined on the I/O Config web page
will appear in this field.
•
Signal State
– this field reports the status of the input signal Present or
Not Present.
•
Sample Rate
– indicates the rate of the audio input stream.
•
Mode
– reports the number of bits: 16, 20, or 24 bits.
•
Audio Mode Status
– shows the audio mode: PCM or Non-PCM.
•
Force Audio Mode
– chooses the audio mode: PCM (Pulse Code Modula-
tion – a method of storing and transmitting uncompressed digital
audio), Non-PCM (non-audio data such as Dolby E or data), or Sync
PCM (audio that already has a 48 kHz sample rate).
Note
When a Force Audio Mode selection is changed, you must manually set the
AES CUV Bits Pass Through control to Enabled or Disabled as desired on
the
Output Status and Settings Web Page on page 43
.
•
AES Error Detected
– reports any errors detected since the last time the
error status was cleared (
Errors
or
None
).
Delay Tracking Input
•
Name
– this name cannot be modified.
•
Signal State
– this field reports the status of the delay tracking input
signal as Present or Not Present.
•
Link
– select this link to go to the Delay web page.
Genlock Input
•
Name
– the genlock input name defined on the I/O Config web page
will appear in this field.
•
Signal State
– this field reports the status of the input signal Present, Not
Present or Not Supported.
•
Link
– select this link to go to the Genlock web page.
Defaults Button
Select the
Defaults
button to restore the default Input signal source.
Use
this
link