Grass Valley 8977AP-4B - Manual (Page 15)

8977AP-4B/4U — Instruction Manual 15
Installation
Front Module Installation
After installing the rear module and the 8900GEN-SM Genlock submodule
if required, install the front module as follows:
1. Unscrew and remove the front cover.
2. Insert the front module in the guides of the corresponding slot.
3. The module ejector tab ( Figure 5 ) must be locked in its locking pin.
Figure 5. Front Module Ejection
8521_03
Slide top and bottom card carriers on module
over top and bottom guides on right of slot.
Module installed
Locking Pin
Card Carriers
Card Carriers
Front Module Side View
Ejector Tab