Grass Valley 8977AP-4B - Manual (Page 11)

8977AP-4B/4U — Instruction Manual 11
Installation
Rear Module Installation
Note Do not completely remove the screws holding the retainer strips as they can
fall into other equipment and create a shorting hazard.
To install a rear module into the frame, follow these steps:
1. Unscrew the blank rear adapter cover (without removing the screws),
with a 2mm (5/64”) hex screwdriver (see
Figure 2 ).
2. Remove the two retainer strips and the blank rear adapter cover using
a pair of needlenose pliers.
3. Insert the corresponding rear module in the slot.
4. Replace both retainer strips on each side of the rear module and tighten
the screws to secure the rear module.
Figure 2. Frame Rear
Note To extract the rear module, remove the front module first.
8521_02