Specifications, Table 5 on – Grass Valley 8925EMB-B v.2.1.6 User Manual
Page 54
54
8925EMB-B and -U — Instruction Manual
Specifications
Specifications
Table 5. Main Features
Main Features
HD/SD video format supported by
SMPTE 274M, SMPTE 296M, and
SMPTE 259M-C
SMPTE 274M:
SMPTE 296M:
SMPTE 259M-C:
1080i/59.94
720p/59.94
480i/59.94
1080i/50
720p/50
576i/50
1080p/23.98
1080sF/23.98
Video processing
• EDH/CRC insertion, detection and reporting
• Video Input Status including incoming embedded audio status
• Video Standard Selection
Embedding processing:
SMPTE 299M
SMPTE 272M Level A, C
SMPTE 337M (no ZCUV bit pass-through)
• Up to four selectable audio groups
• 48 kHz support
• 20 or 24 bit mode or Auto mode
• Auto control packet insertion
Audio processing
• Sample Rate Conversion
• 32 to 96 kHz input rate to 48 kHz output rate
• Synchronous 48 kHz Non PCM format supported (SRC bypass)
• Automatic Dolby E detection and low A/V delay pass-through
• AES input status (presence, error, rate, audio/non-audio)
Maximum power consumption
7.7 Watts/642 mA @ +12V
Video delay from input to output
Refer to
and
for specific lengths
Audio Min. Delay from Input to output
Audio PCM
Audio Min. Delay from Input to Output
Audio Non PCM (Dolby E)
HD/SD Multi-format Auto Detection
Auto sensing and locking time, from loss of
signal or format change to correct signal at
output end
< 0.5 seconds
Note: if it is a switch between HD/HDM formats
(HD 50Hz/HD 59.94Hz) it may be longer: < 1 seconds
Operational frequency range of HD/SD SDI input
Nominal rate ±110 ppm
Mechanical
Frame type
GeckoFlex
Number of frame slots required
1 slot
Rear module type
8925EMB-B
8900BVF-R
8925EMB-U
8900UVF-R
Rear module retainer maximum screw torque
4-5 inch-lb./0.45-0.6Nm