Grass Valley 8925EMB-B v.2.1.6 - Manual (Page 27)

8925EMB-B and -U — Instruction Manual 27
Remote Configuration
Status is reported for each of the following audio and video signals:
• Video inputs indicate the status of the video inputs incoming on the
BNC connectors, one of two possible fiber optic inputs (depending on
the type of the fiber optic SFP device installed),
• Video outputs are always gray as the outputs are not monitored,
• Audio inputs indicate the status of the audio inputs,
• Frame bus indicates the status of the communication bus to the
8900NET module, and
• Fiber module shows if a fiber module is installed. When not installed,
the graphic will be white and report
Fiber Module not Installed .
Note On the 8925EMB modules, input signals are represented by up to five input
signal arrows.
Warning/Fault/Message Reporting
Faults, warnings, and informational messages from the module are dis-
played between the double bars below the graphic.
Module Status
Module status for the front and rear modules (and any SFP devices if appli-
cable) are reported as PASS, WARNING, ERROR, or EMPTY on the right at
the bottom of the display.
Front Module Information
Information about the module, such as part number, serial number, hard-
ware revision and software, firmware, and boot versions, and asset tag
number (assigned on the
Slot Config Web Page on page 46 ) are given on the
left at the bottom of the display.