Grass Valley 8925EMB-B v.2.1.6 - Manual (Page 24)

24 8925EMB-B and -U — Instruction Manual
Remote Configuration
Web Page Headers
Each configuration web page has a Status and Identification Header as
shown in
Figure 10 below.
Figure 10. Web Page Header
The header information on each web page includes the following:
• Model and Description are read-only generated by the module.
• Frame Location is defined on the 8900 Series GeckoFlex frame configura-
tion web page.
• Slot number reports the module’s location in the frame.
• Input Video Standard reports the input video type and rate detected by the
module.
• Input Video reports the status of the video input to the module.
• Fiber Module Type reports (on the Status, I/O Config, Video Input, and
Video Output web pages) the status or type of the fiber optic SFP device
with one of the following four messages:
• Not Installed,
• RX/TX, 1310 nm,
• Dual RX, or
• Dual TX, 1310/1310 nm.
Web pages with configuration parameters each have a Defaults button at the
bottom of the page to allow resetting of default parameters for only that
page. Default values for all parameters are listed in
Table 13 on page 61 .