Grass Valley 8925EMB-B v.2.1.6 - Manual (Page 18)

18 8925EMB-B and -U — Instruction Manual
Power Up
Power Up
The on-board LED indicators are illustrated in Figure 7 . Upon power-up,
the green PWR LED should be on. The CONFIG and FAULT LEDs should
briefly light on and the COMM LED should blink during the module ini-
tialization.
Note When a module is first plugged into a GeckoFlex frame, the 8900NET module
(if present) may report a momentary fault. This will clear once the module has
booted up.
Operation Indicator LEDs
With a valid input signal is connected, the VID IN PRES LED should be on.
Refer to
Table 3 on page 19 to see a complete list of possible operating con-
ditions and the resulting indicator status.
Note LED colors are highlighted in Figure 7 for reference only. They are not
intended to show the state of the module at power up.
Figure 7. Front LEDs Indicators