Grass Valley 8925EMB-B v.2.1.6 - Manual (Page 14)

14 8925EMB-B and -U — Instruction Manual
Installation
Optional Fiber Optic SFP Device Installation
After the front and rear modules have been installed, install the fiber optic
SFP device if being used into the rear module metal cage labeled FIBER
(
Figure 4 on page 15 ). The SFP device is hot-pluggable and may be installed
or removed with power applied to the module.
CAUTION Use anti-static precautions and handle the SFP device carefully when
installing and the removing it. Before inserting the fiber cable, it is important
to clean all fiber connections as described in Fiber Optic Cleaning Require-
ment below.
Refer to Table 1 for the correct model of SFP device to use with different
software versions.
Fiber Optic Cleaning Requirement
Before making any fiber optic cable mating connections, including installa-
tion, and after every de-mating cycle, use an industry standard fiber optic
cleaning kit, including oil-free compressed air, to clean the fiber connectors
and the connectorized fiber end faces. This helps ensure optimum perfor-
mance of the fiber optic interface. Industry standard fiber optic cleaning
kits can be purchased on the web and in electronics stores.
Table 1. Fiber Optic SFP Device Summary
SFP Device Type SW 2.1.3 and later SW 2.1.3 and earlier
SFP-13103G-M1DRX Dual Receiver X –
SFP-13103G-M1DTX Dual Transmitter X –
SFP-13103G-M1TRX Transceiver X –
1310nm-DRL Dual Receiver X X
1310nm-DTL Dual Transmitter X X
1310nm-TRL Transceiver X X