Grass Valley 8925EMB-B v.2.1.6 - Manual (Page 52)

52 8925EMB-B and -U — Instruction Manual
Service
Table of Alarms
Table 3 below describes the different type of alarms reported by the module
to the upper level devices, such as the 8900NET module.
Table 4. Summary of Alarms for 8925EMB-U/-B Module
Alarm
Type
Web Page Text Description
FAULT
LED
VID IN
ERR LED
Comments
Status
Reported to
8900Net &
SNMP
Fault Firmware failure On Off Firmware configuration failure Yes
Fault Firmware DCM Not Locked On
N./A 1
Firmware internal system clock failure Yes
Fault
Bad firmware image
On
A wrong firmware Image has been down-
loaded
Yes
Fault Wrong rear module (incompatible with 8925EMB) On Yes
Fault Fiber module failed, replace On Yes
Fault Power supply failure On Yes
Warning Coax video input signal not detected Flashing Off Yes
Warning Coax video input is invalid or wrong format Flashing On Yes
Warning Fiber 1 video input signal not detected Flashing Off Yes
Warning Fiber 1 video input is invalid or wrong format Flashing On Yes
Warning Fiber 1 video input not supported by hardware Flashing Off
The fiber module does not allow Fiber 1
input
No
Warning Fiber 2 video input signal not detected Flashing Off Video Input Fiber 2 is selected Yes
Warning Fiber 2 video input is invalid or wrong format Flashing On Yes
Warning Fiber 2 video input not supported by hardware FLASH Off Yes
Warning
Hardware configuration does not support selected fiber
video output
Off Off
Fiber module is a RX/TX and user chooses
to enable fiber TX1 or fiber is dual RX
Yes
Warning Audio Input 1 signal not detected. Flashing
N/A 1
Audio Input 1 Monitored but Not Present Yes
Warning Audio Input 2 signal not detected. Flashing Audio Input 2 Monitored but Not Present Yes
Warning Audio Input 3 signal not detected. Flashing Audio Input 3 Monitored but Not Present Yes
Warning Audio Input 4 signal not detected. Flashing Audio Input 4 Monitored but Not Present Yes
Warning Audio integrity lost, please delete all HANC inputs Flashing
User chose to embed a stream without
delete all HANC inputs
Yes
Warning Coax Video Standard does not match with selection Flashing On
Current Coax Video input is not in the
Input Standard Selection table
Yes
Warning Fiber 1 Video Standard does not match with selection Flashing On
Current Fiber 1 Video input is not in the
Input Standard Selection table
Yes
Warning Fiber 2 Video Standard does not match with selection Flashing On
Current Fiber 2 Video input is not in the
Input Standard Selection table
Yes