Grass Valley 8925EMB-B v.2.1.6 - Manual (Page 15)

8925EMB-B and -U — Instruction Manual 15
Installation
To install the fiber optic SFP device:
1. Slide the fiber optic SFP device into the cage connector connected to the
front module at the rear of the frame (label on right. See
Figure 4 .
2. When installed properly, the front end of the SFP device will line up
with the rear module BNCs. Do not try to force it in further.
3. Cable the fiber optic connectors according to the instructions given in
Cabling on page 16 depending on the type of SFP device used.
Figure 4. Fiber Optic SFP Device
To extract the fiber optic SFP device follow the steps below:
1. Remove the fiber cable first.
2. Unlock the module by flipping the handle to the left.
3. Remove the fiber optic SFP device by using its handle.
FIBER
J7
J9
J8
8431_03
r2
Label
Handle
Arrow Indicators:
Dual Receiver
Dual Transmitter
Transceiver