Grass Valley 8925EMB-B v.2.1.6 - Manual (Page 13)

8925EMB-B and -U — Instruction Manual 13
Installation
Front Module Installation
Note Before installing the front module, the rear module must be installed.
Also refer to the Optional Fiber Optic SFP Device Installation on page 14 if the
fiber optic SFP device is present.
After installing the rear module, install the front module as follows:
1. Unlatch and remove the front cover.
2. Insert the front module in the guides of the corresponding slot as
shown in
Figure 3 .
3. When installed properly, the module ejector tab should be locked in its
locking pin.
Note Before extracting the front module, extract the fiber optic SFP device and its
cable first from the fiber optic cage on the rear of the frame.
Figure 3. Front Module Installation
8479_03
Slide top and bottom card carriers on module
over top and bottom guides on right of slot.
Module installed
Locking Pin
Card Carriers
Card Carriers
Front Module Side View
Ejector Tab