Grass Valley 2000NET v3.1 - Manual (Page 30)

30 2000NET Instruction Manual
2000NET Module Interface
Configuration Page for SNMP Setup
The Thomson Grass Valley Modular Control and Monitoring System uses
the Simple Network Monitoring Protocol (SNMP) internet standard for
reporting status information to remote monitoring stations. The 2000NET
Configuration page provides SNMP setup. When SNMP Agent software is
installed on the 2000NET module, enabled status reports are sent to an
SNMP Manager such as the Thomson Grass Valley’s NetCentral II.
Note There are both hardware and software report enable switches for each report.
Both must be enabled for the report to be sent. For information on hardware
switches, see
Enabling Alarms on page 19 . Software report switches are set
on the Configuration page for the Frame, the 2000NET module, and each
module slot.
SNMP Agent Installation
To use SNMP, the SNMP Agent software must be installed on the module.
The Configuration page shown in
Figure 17 is displayed if the agent soft-
ware has not already been installed. When you click on the install button
you will see the license agreement.
Figure 17. Configuring the 2000 Network Module for SNMP
After reading the agreement, click on Agree to finish installing the SNMP
Agent. Clicking the Decline button will abort the SNMP Agent installation.
Figure 18. Installing the SNMP Agent
Use
This
Link