Grass Valley 2000NET v3.1 - Manual (Page 13)

2000NET Instruction Manual 13
Installation
Module Front RJ-45 Connector
When the 2000NET module is installed in a one rackunit 2000 Series frame,
the dual purpose RJ-45 connector on the front of the 2000NET module is
used as the Serial Configuration port for the module. The RJ-45 connector
is configured using the jumper positions shown in
Figure 8 . Use the RS-232
( DIAG ) jumper positions when connecting to a PC for initializing the
2000NET module. The Front Panel jumper configuration is for future use.
CAUTION This is not an Ethernet port. Damage can result from connecting Ethernet
equipment to this connector.
In the three rackunit 2000T3 frame, with the jumpers set in the DIAG posi-
tion, the RJ-45 connector is in parallel with the Serial Configuration port on
the back of the frame (J101).
Note In the 2000T3 frame, the module front connector and rear frame connector
cannot be used at the same time.
Figure 8. Dual Purpose RJ-45 Connector and Jumpers
Figure 9 on page 14 shows the adapter and cable pinout required for the
serial connection to a PC.
Jumper J9
Front Panel functions (future) RS-232 configuration
functions (DIAGnostics)
RJ-45 Connector
8046 -29