Grass Valley 2000NET v3.1 - Manual (Page 17)

2000NET Instruction Manual 17
Power Up
Power Up
The various front LED indicators and configuration switches are illustrated
in
Figure 12 . Upon power-up, all LEDs should light for the duration of the
initialization process. If all LEDs remain on, the module may not be fully
seated in its slot. After initialization the Power OK LED (PWR) will be on
and the red Network Module LED (NM) should go off. All other LEDs
report detected conditions within the frame and the installed modules. If
the NM LED does not go off, the board needs servicing.
Figure 12. LEDs and Configuration Switches
The Frame Status LED is visible through the frame front cover. Table 1 and
Table 2 on page 18 describe the module LEDs and the conditions they indi-
cate.
Rebooting the Module
If you need to reboot the 2000NET module, either remove and replace the
module in the slot or use the GUI to access the Configuration or Network
pages. Both pages have a
Reboot button (see 2000NET Module Interface on
page 29 ).
8046-02
Power OK (PWR) green
Remote Override (REM OVR) yellow
Power Supply 1 (PS1) red
Front Panel (FP) red
Power Supply 3 (PS3) red
Fan Health (FAN) red
Module Health (MOD) red
Frame Bus (FB) red
Ethernet (ETHER) green
Ethernet Link (LNK) green
Power Suppy 2 (PS2) red
Power Suppy 4 (PS4) red
Temperature (TEMP) red
Bi-color
Frame Status LED
(STATUS) red/green
Communication (COMM) yellow
Network Module (NM) red