H3C Technologies H3C SecPath F5020 - Manual (Page 81)

72
[Sysname-context-3-cnt2] allocate interface gigabitethernet 1/0/2 gigabitethernet
1/0/12
[Sysname-context-3-cnt2] quit
4. Configure context cnt3:
# Create context cnt3 and configure a description for it.
[Sysname] context cnt3
[Sysname-context-4-cnt3] description context-3
# Assign context cnt3 to security engine group test. (The ID of the group is 2.)
[Sysname-context-4-cnt3] location blade-controller-team 2
# Set the CPU weight to 2 for the context.
[Sysname-context-4-cnt3] limit-resource cpu weight 2
# Start the context.
[Sysname-context-4-cnt3] context start
It will take some time to start the context...
Context started successfully.
# Assign interfaces GigabitEthernet 1/0/3 and GigabitEthernet 1/0/13 to the context.
[Sysname-context-4-cnt3] allocate interface gigabitethernet 1/0/3 gigabitethernet
1/0/13
[Sysname-context-4-cnt3] quit
Verifying the configuration
# Verify that you can use the switchto context command to log in to the contexts and manage the contexts.
(Details not shown.)