H3C Technologies H3C SecPath F5020 - Manual (Page 60)

51
Displaying and maintaining an IRF fabric
Execute display commands in any view.
Task Command
Display information about all IRF
members.
display irf
Display the IRF fabric topology. display irf topology
Display IRF link information. display irf link
Display IRF configuration. display irf configuration
Display the load sharing mode for
IRF links.
display irf-port load-sharing mode [ irf-port [ member-id/port-number ] ]
Display MAD configuration. display mad [ verbose ]
IRF setup configuration examples
This section provides IRF configuration examples for IRF fabrics that use different MAD mechanisms.
BFD MAD-enabled IRF configuration example
Network requirements
As shown in Figure 18 , set up an IRF fabric at the distribution layer of the network.
• Configure BFD MAD in the IRF fabric and set up BFD MAD links between the member devices.
• Disable the spanning tree feature on the ports used for BFD MAD, because the two features conflict
with each other.