H3C Technologies H3C SecPath F5020 - Manual (Page 31)

22
Configuring a member device description
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure a description for a
member device.
irf member member-id description text
By default, no member device
description is configured.
Configuring IRF link load sharing mode
On an IRF port, traffic is balanced across its physical links. You can configure the IRF port to distribute
traffic based on any combination of the following criteria:
• Source or destination IP address.
• Source or destination MAC address.
Configure the IRF link load sharing mode for IRF links in system view or IRF port view:
• In system view, the configuration is global and takes effect on all IRF ports.
• In IRF port view, the configuration is port specific and takes effect only on the specified IRF port.
An IRF port preferentially uses the port-specific load sharing mode. If no port-specific load sharing mode
is available, the IRF port uses the global load sharing mode.
Configuring the global load sharing mode
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the global IRF link
load sharing mode.
irf-port global load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
By default, packets are
distributed across IRF member
links automatically based on
their packet types.
If you execute this command
multiple times, the most recent
configuration takes effect.
Configuring a port-specific load sharing mode
Before you configure a port-specific load sharing mode, make sure you have bound a minimum of one
physical interface to the IRF port.
To configure a port-specific load sharing mode for an IRF port:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter IRF port view. irf-port member-id/port-number N/A