H3C Technologies H3C SecPath F5020 - Manual (Page 21)

12
Figure 7 BFD MAD scenario
BFD MAD (distributed devices)
BFD MAD can work with or without intermediate devices. Figure 8 shows a typical BFD MAD application
scenario.
To use BFD MAD:
• Set up a dedicated BFD MAD link between each pair of IRF members or between each IRF member
and the intermediate device. Do not use the BFD MAD links for any other purposes.
• Assign the ports connected by BFD MAD links to the same VLAN.
• Create a VLAN interface for the VLAN, and assign a MAD IP address to each member on the VLAN
interface.
NOTE:
The MAD addresses identify the member devices and must belong to the same subnet.
With BFD MAD, the master tries to establish BFD sessions with other member devices by using its MAD
IP address as the source IP address.
• If the IRF fabric is integrated, only the MAD IP address of the master is effective. The master cannot
establish a BFD session with any other member. If you execute the display bfd session command,
the state of the BFD sessions is Down.
• When the IRF fabric splits, the IP addresses of the masters in the split IRF fabrics take effect. The
masters can establish a BFD session. If you execute the display bfd session command, the state of
the BFD session between the two devices is Up.