H3C Technologies H3C SecPath F5020 - Manual (Page 39)

30
Configuration procedure
1. Configure Device A:
# Bind Ten-GigabitEthernet 1/0/24 to IRF port 1/2, and save the configuration.
system-view
[Sysname] interface ten-gigabitethernet 1/0/24
[Sysname-Ten-GigabitEthernet1/0/24] shutdown
[Sysname-Ten-GigabitEthernet1/0/24] quit
[Sysname] irf-port 1/2
[Sysname-irf-port1/2] port group interface ten-gigabitethernet 1/0/24
[Sysname-irf-port1/2] quit
[Sysname] interface ten-gigabitethernet 1/0/24
[Sysname-Ten-GigabitEthernet1/0/24] undo shutdown
[Sysname-Ten-GigabitEthernet1/0/24] quit
[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
2. Configure Device B:
# Change the member ID of Device B to 2, and reboot the device to validate the change.
system-view
[Sysname] irf member 1 renumber 2
Warning: Renumbering the device number may result in configuration change or loss.
Continue? [Y/N]:y
[Sysname] quit
reboot
# Connect Device B to Device A (see Figure 14 ).
# Log in to Device B. (Details not shown.)
# Bind Ten-GigabitEthernet 2/0/24 to IRF port 2/1, and save the configuration.
system-view
[Sysname] interface ten-gigabitethernet 2/0/24
[Sysname-Ten-GigabitEthernet2/0/24] shutdown
[Sysname-Ten-GigabitEthernet2/0/24] quit
[Sysname] irf-port 2/1
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/0/24
[Sysname-irf-port2/1] quit
[Sysname] interface ten-gigabitethernet 2/0/24
[Sysname-Ten-GigabitEthernet2/0/24] undo shutdown
[Sysname-Ten-GigabitEthernet2/0/24] quit
[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
The two devices perform master election, and the one that fails the election reboots to form an IRF
fabric with the master. In this example, Device B reboots.
3. Configure BFD MAD:
# Create Route-Aggregation 3.
system-view