H3C Technologies H3C SecPath F5020 - Manual (Page 48)

39
To configure IRF ports:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Ethernet interface view
or interface range view.
• Enter interface range view:
{
Method 1:
interface range { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5>
{
Method 2:
interface range name name
[ interface { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5> ]
• Enter interface view:
interface interface-type
interface-number
To shut down a range of IRF
physical interfaces, enter
interface range view.
To shut down one IRF physical
interface, enter its interface
view.
3. Shut down the physical
interfaces.
shutdown
If you cannot shut down a
physical interface, follow the
system instruction to shut down
its peer interface.
4. Return to system view. quit N/A
5. Enter IRF port view. irf-port member-id/port-number N/A
6. Bind each physical interface
to the IRF port.
port group interface interface-type
interface-number [ mode { enhanced |
normal } ]
By default, no physical interfaces
are bound to an IRF port.
Repeat this step to assign
multiple physical interfaces to
the IRF port.
You can bind a maximum of
eight physical interfaces to an
IRF port.
Make sure the two ends of an IRF
link use the same binding mode.
7. Return to system view. quit N/A