Cq configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 53
44
CQ configuration example
NOTE:
•
The configuration examples were created on a WX5004 access controller and may vary with device
models.Check
to see where you configure Ethernet interfaces.
Network requirements
Configure CQ to assign packets from interface GigabitEthernet 1/0/1 to queue 1 and specify queue 1
to send 1635000 bytes during a cycle of round robin queue scheduling.
Configuration procedure
# Enter system view.
# Configure queue 1 as the default queue in CQ list 1.
[Sysname]qos cql 1 default-queue 1
# Configure CQ list 1 to assign packets with local precedence value 4 to queue 1.
[Sysname]qos cql 1 local-precedence 4 queue 1
# Set the maximum length of queue 1 to 1000 in CQ list 1.
[Sysname]qos cql 1 queue 1 queue-length 1000
# Configure queue 1 to send 1635000 bytes in a cycle of round robin queue scheduling in CQ list 1.
[Sysname]qos cql 1 queue 1 serving 1635000
# Apply CQ list 1 to interface GigabitEthernet1/0/1, and configure interface GigabitEthernet 1/0/1 to
use the 802.1p priority of received packets for priority mapping.
[Sysname]interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1]qos cq cql 1
[Sysname-GigabitEthernet1/0/1]qos trust dot1p
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points