H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 13)

4
ACL configuration task list
Task Remarks
Configuring a time range
Optional
Applicable to IPv4 and IPv6 ACLs.
Configuring a WLAN ACL
Required
Configure at least one task.
Applicable to IPv4 and IPv6.
Configuring a basic ACL
Configuring an advanced ACL
Configuring an Ethernet frame header ACL
Copying an ACL
Optional
Applicable to IPv4 and IPv6.
Configuring a time range
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure a time range.
time-range time-range-name
{ start-time to end-time days [ from
time1 date1 ] [ to time2 date2 ] |
from time1 date1 [ to time2 date2 ]
| to time2 date2 }
By default, no time range exists.
Repeat this command with the
same time range name to create
multiple statements for a time
range.
You can create multiple statements in a time range. The active period of a time range is calculated as
follows:
1. Combining all periodic statements
2. Combining all absolute statements
3. Taking the intersection of the two statement sets as the active period of the time range
You can create a maximum of 256 time ranges, each with 32 periodic statements and 12 absolute
statements at most.
Configuring a WLAN ACL
WLAN ACLs match packets based on SSIDs of wireless clients.
To configure a WLAN ACL:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a WLAN ACL and
enter its view.
acl number acl-number
By default, no ACL exists.
WLAN ACLs are numbered in the
range 100 to 199.