H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 14)

5
Step Command Remarks
3. Configure a description for
the WLAN ACL.
description text
Optional.
By default, a WLAN ACL has no
ACL description.
4. Set the rule numbering step. step step-value
Optional.
5 by default.
5. Create or edit a rule.
rule [ rule-id ] { permit | deny }
[ ssid ssid-name ]
By default, a WLAN ACL does not
contain any rule.
To create or edit multiple rules,
repeat this step.
6. Configure or edit a rule
description.
rule rule-id comment text
Optional.
By default, a WLAN ACL rule has
no description.
Configuring a basic ACL
Configuring an IPv4 basic ACL
IPv4 basic ACLs match packets based on only source IP address.
To configure an IPv4 basic ACL:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an IPv4 basic ACL
and enter its view.
acl number acl-number [ name
acl-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv4 basic ACLs are numbered in the
range 2000 to 2999.
You can use the acl name acl-name
command to enter the view of a named
IPv4 ACL.
3. Configure a description
for the IPv4 basic ACL.
description text
Optional.
By default, an IPv4 basic ACL has no
ACL description.
4. Set the rule numbering
step.
step step-value
Optional.
5 by default.
5. Create or edit a rule.
rule [ rule-id ] { deny | permit }
[ counting | source { sour-addr
sour-wildcard | any } |
time-range time-range-name ] *
By default, an IPv4 basic ACL does not
contain any rule.
To create or edit multiple rules, repeat
this step.
6. Configure or edit a rule
description.
rule rule-id comment text
Optional.
By default, an IPv4 ACL rule has no rule
description.