H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 51)

42
Step Command Remarks
7. Display PQ list configuration
information
display qos pq interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Optional.
Available in any view
8. Display the contents of the
specific PQ list or all the PQ
lists
display qos pql [ pql-number ] [ |
{ begin | exclude | include }
regular-expression ]
Optional.
Available in any view
PQ configuration example
NOTE:
•
The configuration examples were created on a WX5004 access controller and may vary with device
models.Check
Table 7 to see where you configure Ethernet interfaces.
Network requirements
As shown in Figure 14 , Client A and Client B get data from Server through the wireless controller AC.
When the traffic from the Server to clients enters the AC, the traffic is assigned local precedence 5
through priority mapping. Configure the AC to preferentially process traffic with local precedence 5.
Figure 14 Network diagram
Configuration procedure
# Enter system view.
system-view
# Configure PQ list 1 to assign packets that match no criteria to the middle queue.
[AC] qos pql 1 default-queue middle
# Configure PQ list 1 to assign packets with local precedence value 5 to the top queue.
[AC] qos pql 1 local-precedence 5 queue top
# Set the maximum length to 1000 for the middle queue in PQ list 1.
[AC] qos pql 1 queue middle queue-length 1000