H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 11)

2
Match order
The rules in an ACL are sorted in certain order. When a packet matches a rule, the device stops the match
process and performs the action defined in the rule. If an ACL contains overlapping or conflicting rules,
the matching result and action to take depend on the rule order.
The following ACL match orders are available:
• config—Sorts ACL rules in ascending order of rule ID. A rule with a lower ID is matched before a
rule with a higher ID. If you use this approach, check the rule content and order carefully.
• auto—Sorts ACL rules in depth-first order. Depth-first ordering guarantees that any subset of a rule
is always matched before the rule.
Table 1 lists the sequence of tie breakers that depth-first ordering
uses to sort rules for each type of ACL.
NOTE:
The match order of WLAN ACLs can only be config.
Table 1 Sort ACL rules in depth-first order
ACL category Sequence of tie breakers
IPv4 basic ACL
1. More 0s in the source IP address wildcard (more 0s means a narrower IP
address range)
2. Smaller rule ID
IPv4 advanced ACL
1. Specific protocol type rather than IP (IP represents any protocol over IP)
2. More 0s in the source IP address wildcard mask
3. More 0s in the destination IP address wildcard
4. Narrower TCP/UDP service port number range
5. Smaller ID
IPv6 basic ACL
1. Longer prefix for the source IP address (a longer prefix means a narrower IP
address range)
2. Smaller ID
IPv6 advanced ACL
1. Specific protocol type rather than IP (IP represents any protocol over IPv6)
2. Longer prefix for the source IPv6 address
3. Longer prefix for the destination IPv6 address
4. Narrower TCP/UDP service port number range
5. Smaller ID
Ethernet frame header ACL
1. More 1s in the source MAC address mask (more 1s means a smaller MAC
address)
2. More 1s in the destination MAC address mask
3. Smaller ID
NOTE:
A wildcard mask, also called an inverse mask, is a 32-bit binary and represented in dotted decimal
notation. In contrast to a network mask, the 0 bits in a wildcard mask represent 'do care' bits, and the 1
bits represent 'don't care' bits. If the 'do care' bits in an IP address are identical to the 'do care' bits in an
IP address criterion, the IP address matches the criterion. All 'don't care' bits are ignored. The 0s and 1s
in a wildcard mask can be noncontiguous. For example, 0.255.0.255 is a valid wildcard mask.