H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 52)

43
# Apply PQ list 1 to interface GigabitEthernet 1/0/1 and configure interface GigabitEthernet 1/0/1 to
use the 802.1p priority of the received packets for priority mapping.
[AC] interface gigabitethernet1/0/1
[AC-GigabitEthernet1/0/1] qos pq pql 1
[AC-GigabitEthernet1/0/1] qos trust dot1p
Configuring CQ
You can configure a CQ list that contains up to 16 queues (1-16), with each queue including the match
criteria for packets to enter the queue, the length of the queue and the bytes sent from the queue during
a cycle of round robin queue scheduling. Only one CQ list can be applied to an interface.
Configuration procedure
To configure CQ:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure a CQ list.
qos cql cql-index protocol ip
[ queue-key key-value ] queue
queue-number
or
qos cql cql-index local-precedence
local-precedence-value queue
queue-number
Optional.
Use a command as needed.
3. Specify the default queue.
qos cql cql-index default-queue
queue-number
Optional.
This command specifies the queue
to which unmatched packets are
assigned.
1 by default.
4. Set the length of a queue.
qos cql cql-index queue
queue-number queue-length
queue-length
Optional.
5. Configure the bytes sent from
a queue during a cycle of
round robin queue
scheduling.
qos cql cql-index queue
queue-number serving byte-count
Optional.
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Apply the CQ list to the
interface.
qos cq cql cql-index FIFO applies by default.
8. Display interface CQ list
configuration information.
display qos cq interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Optional.
Available in any view
9. Display information about CQ
lists.
display qos cql [ cql-index ] [ |
{ begin | exclude | include }
regular-expression ]
Optional.
Available in any view