H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 33)

24
• dot11e-lp—802.11e-to-local priority mapping table.
• dot1p-lp—802.1p-to-local priority mapping table.
• dscp-lp—DSCP-to-local priority mapping table.
• lp-dot11e—Local-to-802.11e priority mapping table.
• lp-dot1p—Local-to-802.1p priority mapping table.
• lp-dscp—Local-to-DSCP priority mapping table.
To configure a priority mapping table:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter priority mapping table
view.
qos map-table { dot11e-lp |
dot1p-lp | dscp-lp | lp-dot11e |
lp-dot1p | lp-dscp }
N/A
3. Configure the priority
mapping table. import import-value-list export
export-value Newly configured mappings
overwrite the old ones.
Configuring a port to trust packet priority for priority
mapping
You can configure the device to trust a particular priority field carried in packets for priority mapping on
ports or globally.
When configuring the trusted packet priority type on an interface or port group, use the following
available keywords:
• dot11e—Uses the 802.11e priority of received packets for mapping.
• dot1p—Uses the 802.1p priority of received packets for mapping.
• dscp—Uses the DSCP precedence of received IP packets for mapping.
To configure the trusted packet priority type on an interface or port group:
Step Command Remarks
1. Enter system view. system-view —
2. Enter interface view or
port group view.
• Enter interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual port-group-name
Use either command.
Settings in interface view (Ethernet
or WLAN-ESS) take effect on the
current interface. Settings in port
group view take effect on all ports
in the port group.
3. Configure the trusted
packet priority type for
the interface. qos trust { dot11e | dot1p | dscp }
By default, port priority is trusted.
The dot11e keyword is only
available on WLAN-ESS
interfaces.