H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 37)

28
Verifying the configuration
Use a PC to send flows with different priorities to the wireless clients connected to the three APs. After
these packets enter the AC, their priorities are mapped to different priorities. You can determine the
802.11e priority of each flow by capturing the packets sent out GigabitEthernet 1/0/1 to different APs.
Port priority configuration example
Network requirements
As shown in Figure 6 , the AC processes the packets of AP 1, AP 2, and AP 3. Configure the AC to make
sure that:
• Incoming packets are assigned local precedence values through priority mapping based on the
port priority of receiving ports.
• The default priority mapping tables of the AC are used.
• The wireless interface of AP 1 is WLAN-ESS 1, that of AP 2 is WLAN-ESS 2, and that of AP 3 is
WLAN-ESS 3.
Figure 6 Network diagram
Configuration procedure
# Enter system view.
system-view
# Configure the port priority of interface WLAN-ESS1 as 1.
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] qos priority 1
[AC-WLAN-ESS1] quit
# Disable service template 1 before binding it with interface WLAN-ESS 1.
[AC] wlan service-template 1
[AC-wlan-st-1] service-template disable
[AC-wlan-st-1] ssid office1
[AC-wlan-st-1] bind wlan-ess 1
# Enable service template 1.
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
# Configure the port priority of WLAN-ESS 2 as 3.
[AC] interface WLAN-ESS 2