beautypg.com

Vpm slot, Installing/removing a vpm card – H3C Technologies H3C MSR 20-1X User Manual

Page 69

background image

62

VPM Slot

Figure 44 Structure of VPM slot

Installing/Removing a VPM Card

Follow these steps to install a VPM card:

Step1

Make sure no power supply is present before proceeding with the next step.

Step2

Align the connecting fingers of the VPM card with the slot on the main control board.

Step3

Form an angle of 45 degrees between the VPM card and the main board and insert the VPM card into

the slot.

Step4

Press the top edges of the VPM card and exert a force in the direction shown in the figure below until you

hear a click. This indicates the VPM card has snapped into the slot. After the VPM card is installed, the

VPM card must be vertical to the main control board.

Figure 45 Install the VPM card into the slot

Follow these steps to remove the VPM card:

Step1

Make sure no power supply is present before proceeding with the next step.

Step2

Press the ejector clips on the two sides of the VPM slot and pull them outwards respectively until the VPM

card is separated from the slot.

Step3

Remove the VPM card.

This manual is related to the following products: