Installing the router on a workbench, Installing the router on a cabinet, Dimensions – H3C Technologies H3C MSR 20-1X User Manual
Page 25: Installation procedure
18
•
In a cabinet
•
On a wall
Installing the Router on a Workbench
In case that no 19-inch standard cabinet is available, you can put the router on a clean workbench.
When installing the router on a workbench,
•
Make sure that the workbench is stable and well grounded.
•
Reserve a space of 10 cm (3.9 in.) around the router for heat dissipation.
•
Do not place heavy objects on the router.
Installing the Router on a Cabinet
Dimensions
With mounting brackets, you can also install MSR 20-1X routers in a 19-inch standard cabinet.
The dimensions of MSR 20-1X routers without feet and mounting bracket are 44.2 × 300 × 240 mm (1.74
× 11.81 × 9.45 in.).
Installation procedure
Step1
Check that the cabinet is stable and properly grounded. Attach two mounting brackets to the front or rear
panel of the router with screws.
Step2
Put the router in a tray. Depending on the actual situation, slide the router along the guide rails to an
appropriate position, keeping a proper distance between the router and guide rails.
Step3
Fix the router horizontally by fastening the mounting brackets to the cabinet with appropriate pan head
screws. The specifications of pan head screws should satisfy the installation requirements and rustproof
treatment has been made to their surfaces.
Figure 12 Install an MSR 20-1X router in a cabinet
(1) Mounting brackets